SPRAY APPARATUS T1-32

COMPLIANCE

T1-32 MOTOR DRIVE FOR SPRAY APPARATUS is designed and manufactured in compliance with IEC 60529,… 

INTRODUCTION

T1-32 MOTOR DRIVE FOR SPRAY APPARATUS is intended for determining the degree of protection, against ingress of water IPX3 and IPX4. 

MAIN FEATURES

OSCILLATING MECHANISM WITH TUBE CARRIER, ELECTROMOTOR AND ADJUSTABLE CARRIER OF SUPPORTING END BEARING

  • can be rotated around the basic vertical carrying tube; this enables the use of same space for either IPX1,2 or IPX3,4 test

  • Height of oscillating mechanism can be adjusted

  • Mounting (changing) of oscillating tubes can be easily achieved by simple insertion of tube and tightening of knurled nuts. 

MAIN CONTROL UNIT

  • Water proof plastic casing, should be mounted on a wall, so that it enables the operator to stay dry

  • Start and stop buttons

  • Timer for test duration

  • Knob for oscillation speed

  • Switch for turning water on/off

  • Elements of control circuit are supplied by 24 V AC

  • After the operating time, that had been set on the timer, runs out the tube returns to vertical position, apparatus is switched off, and the water is shut off.

WATER SUPPLY UNIT

  • Attached on the wall console, so that it enables the operator to stay dry

  • Manual valve for flow controlling

  • Water filter 

  • Flow meter

  • Manometer

  • Electromagnetic valve that is controlled by control unit

ANGLE CONTROL UNIT

  • Control of oscillation angles

  • Control of stop position (usually vertical)

  • Monitoring of tube position

  • This unit is so designed that it is possible to conduct symmetric and asymmetric oscillations with steplessly adjustable both end positions and stop position. 

  • Equipped with scale (180 deg), three limit sensors and pointer

DESCRIPTION

Electromotor is supplied by 3-phase voltage 220 V that is generated by frequency transformer (motor controller) with feed-back regulation. The controller also enables steplessly adjustable braking (and acceleration) that is performed each time before and after the change of direction of the tube. This should be done to ensure uniform unwavering oscillating of the tube. The current is also limited for the reason of motor protection. If oscillating tube strikes in obstacle during operation, adjustable electronic current limiter limits the torque on the shaft of electromotor and protects the tube, the motor and the obstacle (person or sample). Oscillating tube stops until the obstacle is removed, and after that normally continues oscillating.

Address

PNK Engineering and Consultant Co., Ltd. 
222 UPA Place Building B  1st Floor
Soi Ramkumhange 164 Minburee 
Bangkok 10510

Contact

Tel +669 4412 5588   +66 2 170 9244
Fax +66 2 170 9245 

©2018 by PNK Engineering & Consultant create by Big Bear